Quantcast
Industry Cortex

Document Brief

C701/C701A and C703/C703A Alternators...

OEM Installation Instructions...

This symbol is used to indicate the presence of hazards that can cause severe personal injury or substantial property damage. This symbol is used to indicate the presence of hazards that can cause minor personal injury or property damage. b. 2. Re-install regulator on drive end housing and torque mounting screws to 8.5 Nm/75 lb. in....

Install alternator a. Carefully place alternator on alternator mounting bracket....

If an extended wiring harness is supplied with alternator and regulator, see separate instructions packed with harness....

1. A2-213, A2-214, and A2-325 regulators are flat-temperature compensated and factory-set at lowest setting to accommodate 8D batteries. For other batteries a. Remove regulator from housing and change position on voltage selector switch. See Table 1....

Table 1 Regulator Voltage Selector Switch Position Position 1 2 3 4 27.5 V 28.0 V 28.5 V 29.0 V Battery Type Maintenance Maintenance Maintenance-Free Maintenance-Free ...

Use caution when lifting alternator to prevent possible minor personal injury. Use hoist along with alternator lifting ring located on top of alternator....

Secure alternator to alternator mounting bracket using four 1/2-13, grade 5 or higher mounting bolts with lock washers. Mounting bolts should extend 17.8/25.4 mm (0.7/1.0 in.) into alternator mounting rail. Torque mounting bolts to 88 Nm/65 lb. ft....

Units are shipped with pulley and hardware already assembled. Install alternator drive belt and secure belt tension bracket assembly. Loop alternator drive belt over pulleys and align belt with polyvee grooves....

Use this setpoint to maintain proper battery charge level during shorter operating cycles....

Alternator lifting ring Cable clamp A2-214/A2-325 P terminal 1/4-20 nut torque to 3.4 Nm/30 lb. in. A2-213 P terminal M6 nut torque to 4.5 Nm/40 lb. in....

A2-214/A2-325 IGN terminal #10-24 nut torque to 3.4 Nm/30 lb. in. A2-213 IGN terminal M5 nut torque to 4.5 Nm/40 lb. in. A2-214/A2-325 D+ terminal 1/4-20 nut torque to 3.4 Nm/30 lb. in. A2-213 D+ terminal M6 nut torque to 4.5 Nm/40 lb. in. C701/C701A 1/2-13 bolt torque to 30 Nm/22 lb. ft. C703/C703A M12 bolt torque to 30 Nm/22 lb. ft. Battery output cable terminal...

Lock washer...

Flat washer Insulator...

B+ terminal see inset above...

C701/C701A 3/4-16 nut torque to 163 Nm/120 lb. ft. C703/C703A M20 x 1.5 mm fl...

Document Keywords

II0071D documents ctrl hyperlink ii0071d uid41920101037581

Sponsored Products

About C.E. Niehoff & Co.

DB desc tag

Contact

847-866-6030, 888-643-4633 (toll free)
Fax: 847-492-1242

sponsored links